What is FOTONA-3D?
Fotona 3D treatment enables the full contraction of collagen for increase efficacy in skin tightening without any injectables and surgery. With this advanced technology laser, anti-aging is comprehensively approached from 3 different levels, working on deeper, medial, and superficial connective structures of the skin, as well as targeting imperfections. The three “dimensions” of Fotona 3D refer to three distinct treatments with Fotona’s SP Dynamis system: FRAC3, PIANO, and SuperficialTM, all harnessed in concert to combat NECK aging, with little or no downtime and no pain, and that can be performed all year-round
.
What can FOTONA-3D NECK do?
This new technology allows non-invasive/non-surgical Neck lifting, Skin tightening, Reduction of jowls, fine lines and wrinkles, more defined jawline, reduction of double chin, improvement of loss of volume, brightening, and evens up skin tone.
How does it work?
Step 1 – FRAC3 Mode uses a fractional beam that targets deeper imperfections to restore a youthful texture and tone to the skin.
Step 2 – PIANO Mode is a safe and fast bulk tissue heating from the outside in by concentrating energy delivery subcutaneously. Bulk heating is used to tighten the skin more effectively.
Step 3 – SupErficial Mode is used lastly to improve the appearance of the skin and reduce imperfections with an extremely controlled light peel or skin resurfacing according to the skin condition. This gives the skin a smoother pearl finish, smoother skin texture, radiance, and even skin tone.
1. How long will it take to see results?
Omni: Results vary among individuals but most patients can see some immediate results after the 1st treatment. The end results can be visibly seen after 2-3months. Should you opt for more aggressive treatment, you may have redness on your neck 1-2days thereafter
.
2. What does the procedure feel like?
Omni: The experience may not be the same for everyone but generally a warm sensation will be felt by patients. For more aggressive treatments, you may feel a much hotter sensation around the treated area but the heat will dissipate quickly
3. Does the procedure require any downtime?
Omni: No, the treatment is non-surgical and non-invasive.
4. How many sessions do I need?
Omni: Recommends 3-6 sessions, to lasts up to 1 year. Subsequently, you can repeat 1 session every year as maintenance therapy.
5. How long is each session and what is the interval for each session.
Omni: Each session takes approximately 1hour, the interval in between each session should be at least 3-6weeks
6. Is this machine FDA approved?
Omni: Yes, it is FDA approved.
Fotona NeckTite is a unique non-ablative laser treatment for sculpting and skin tightening on the neck area.
The exclusive delivery modes are used in concert for hyperthermic adipocyte destruction and collagen remodeling with exceptional results. It's different from 3D Fotona as it's focused more on horizontal necklines, fine and deep neck wrinkles, and aging skin. It tightens the skin, increases blood flow to the area, and also helps to improve the quality of the skin.
1. How long will it take to see results?
Omni: Results vary among individuals but most patients can see some immediate results after the 1st treatment. The end results can be visibly seen after 2-3months. Should you opt for more aggressive treatment, you may have redness on your neck 1-2days thereafter.
2. What does the procedure feel like?
Omni: The experience may not be the same for everyone but generally a warm sensation will be felt by patients. For more aggressive treatments, you may feel a much hotter sensation around the treated area but the heat will dissipate quickly
3. Does the procedure require any downtime
Omni: No, the treatment is non-surgical and non-invasive but, you may notice some redness and slight swelling for 4-6 hours. Also, some dryness and light skin peeling for 24-48 hours.
4. How many sessions do I need?
Omni: Recommends 3-6 sessions, to lasts up to 1 year. Subsequently, you can repeat 1 session every year as maintenance therapy.
5. How long is each session and what is the interval for each session.
Omni: Each session takes approximately 1hour, the interval in between each session should be at least 3-6weeks. Customers have questions, you have answers.
6. What is post-procedure care?
Omni: Apply moisturizer generously, avoid using products that contain lactic acid, salicylic acid, and retinol for 7-10 days.
Image courtesy of Fotona®
Copyright © 2021 OMNI Medical & Surgical Esthetics Regina.